Whirlpool 24-Inch Installation Instructions - Page 13

Option 2, Dishwasher with Stainless Steel Tub Side Attachment (for marble, granite or other hard surface countertops) 1. Remove the brackets from the parts package. 2. Break off the end of the bracket along the scored line. Built-uflpoors(Kitcheflnoorheighist highethr ancabinet openingE.x) ampKlei:tchefnlootriledoesnotextenidnto cabineotpeninAg.ddshimassneedeidntheareashowtno bringthedishwashueprto34"(86.4cm)belowthecountertop. NOTES:himms usbt esecurealyttachetodfloortoavoid movemewnht enthedishwashiseirnuse. 3. With another person holding the dishwasher to avoid it from tipping, open dishwasher door, and place towel over pump assembly and spray arm of dishwasher. This will stop screws from falling into pump area when securing dishwasher to cabinet. 4. Push the plastic buttons out of the side of the tub. NOTE: Save the buttons to cover the holes after dishwasher is installed. Excessive Weight Hazard Use two or more people to move and install dishwasher. Failure to do so can result in back or other injury. Using two or more people, stand the dishwasher up. IMPORTANT: The dishwasher must be secured to the cabinet. There are two brackets, found in the parts bag, attach the brackets to the top of the dishwasher if the countertop if it is wood, laminate or another similar surface. If your countertop is marble, granite or another hard surface, install using Option #2. Option 1, Countertop attachment 1. Remove the brackets from the package and place in the open slots on the left and right-hand top of the dishwasher collar as shown. 5. Push bracket into slot on the side of dishwasher, and bend tab in toward the side of the dishwasher so that it keeps the bracket in place. NOTE: Do not attach the dishwasher. This will be done later. Bend tab - side mount Option 3, Dishwasher with Plastic Tub Side Attachment (for marble, granite or other hard surface countertops) Order Mounting Bracket Kit Part Number 8212560. Move Dishwasher info Cabinef Opening 11 Stand dishwasher upright 2. Insert the bracket into the slot on the collar. Using a pair of pliers, bend the tab down to secure the bracket in place. Repeat this step for the other side. NOTE: Do not attach the dishwasher. This will be done later. Using two or more people, stand dishwasher upright. NOTE: Do not install kickplate until instructed to do so. 13