Whirlpool 24-Inch Installation Instructions - Page 20

Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong• Do not use an adapter• Do not use an extension cord• Failure to follow these instructions in death, fire, or electrical shock• can result Check Operation [_ Read the Dishwasher User instructions that came with your dishwasher. [_1 Check that all parts have been installed and no steps were skipped. Check that you have all tools used. C3Start dishwasher and allow it to complete the shortest wash cycle. After the first 2 minutes unlatch door, wait 5 seconds, then open door. Check to see that there is water in the bottom of the dishwasher tub. Check that dishwasher is working properly. if dishwasher is not working properly, disconnect power or unplug dishwasher and see "if Dishwasher Does Not Operate" section. Plug into a grounded 3 prong outlet. Check that power supply cord does not touch dishwasher motor or lower part of dishwasher tub. Reconnect Power 20 • Has the circuit breaker tripped or the house fuse blown? • is the door closed tightly and latched? • Has the cycle been set correctly to start the dishwasher? • is the water turned on? if none of these work, call 1-800-253-1301, or in Canada, call 1-800-807-6777. For Roper models, call 1-800-447-6737, or in Canada call 1-800-807-6777. Additional Tips Expect longer wash times. Your new dishwasher will average 2 to 3 hours per load, but use nearly 40% less energy than older models. Designed with a low wattage, low energy consumption motor, your dishwasher washes longer to ensure exceptional cleaning. Certain models are equipped with an optical water sensor so the first cycle will run longer to calibrate to optical sensor. Selecting certain options could increase cycle time past 3.5 hours. Rinse Aid is necessary for good drying results: This dishwasher is designed to be used with rinse aid for good drying performance and controlling hard water deposit buildup. Energy efficient dishwashers use less water and energy so they depend on the water sheeting action of rinse aid for good drying performance. Start/Resume light may flash: When pressing Start/Resume, you must make sure the door is closed within 3 seconds. If you do not, the Start/Resume light will flash until you press it again. (You must also do this when adding a dish during the middle of a cycle.) NOTE: If a braided supply hose is used, replace inlet hose after 5 years to reduce the risk of hose failure. Record hose installation or replacement dates on the hose for future reference.