Whirlpool WHD3090G Owners Manual - Page 13
Cleaning The Bottom Filter, Non-use, Storage, And Moving Care, Non-use, Storage, And, Moving Care
View all Whirlpool WHD3090G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
CLEANING THE BOTTOM FILTER Clean bottom filter after every 5 loads. The filter is located in bottom corner of dryer. 1. Open the filter door on the bottom of the dryer and grab the handle to pull out the filter. Remove the foam from the bottom filter. Clean the filter foam and the filter by hand or rinse with water - do not wash the filter foam in a washer. Wring out the filter foam - do not insert it in the bottom filter dripping wet. 2. Replace the filter foam on the bottom filter. Replace the bottom filter in the filter chamber. Fold the filter handle down and close the bottom door. IMPORTANT: n Do not run the dryer with the filter loose, damaged, blocked, or missing. Doing so can cause overheating and damage to both the dryer and fabrics. NON-USE, STORAGE, AND MOVING CARE (cont.) For direct-wired dryers: 1. Empty water tank. 2. Disconnect power. 3. Disconnect wiring. 4. Make sure leveling legs are secure in dryer base. 5. Use tape to secure dryer door. Reinstalling the Dryer Follow the "Installation Instructions" section to locate, level, and connect the dryer. NON-USE, STORAGE, AND MOVING CARE Non-Use or Storage Care If you will be on vacation or not using your dryer for an extended period of time, you should: 1. Empty water tank. 2. Unplug dryer or disconnect power. 3. Clean lint screen. See "Cleaning the Lint Screen." 4. In colder climates, store your dryer where it will not freeze. Because some water may stay in the hose, freezing can damage your dryer. Moving Care For power supply cord-connected dryers: 1. Empty water tank. 2. Unplug the power supply cord. 3. Make sure leveling legs are secure in dryer base. 4. Use tape to secure dryer door. 13