Whirlpool WHD3090G Owners Manual - Page 32

TROUBLESHOOTING First try the solutions suggested here or visit our website at www.whirlpool.com/product_help - In Canada www.whirlpool.ca for assistance and to possibly avoid a service call. If you experience Possible Causes Solution Dryer Displays Code Message or LED Symbol Lights Up Water tank is filled with water. Empty water tank; make sure to insert it properly afterwards. F01 to F04 F05 to F09 F10 to F24 Water tank is not correctly positioned. Push in the water tank to make sure that it is correctly inserted in the tank compartment. Bottom filter is blocked by lint. Bottom filter is not correctly positioned. Door filter is blocked by lint. Door filter is not correctly positioned. A component has failed. A component has failed. A component has failed. Clean the bottom filter; make sure to insert it properly afterwards. Push in the bottom filter and move the release levers into a vertical position to make sure the filter is correctly inserted in the filter compartment. Close the flap. Remove and clean the door filter; afterwards, make sure to insert it properly in the filter compartment. Check position of the door filter; make sure that it is properly inserted in the filter compartment. Touch and hold the Power button for at least 3 seconds while dryer is on. Turn off and unplug the dryer. Immediately open the door and take out the laundry so that the heat can dissipate. Make sure that the ambient temperature ranges between 41°F (5°C) and 95°F (35°C). After about one hour, plug in the dryer, load the laundry, and start the program/cycle again. If the failure persists, call for service. Turn off and unplug the dryer. After about half an hour, plug in the dryer and start the program/cycle again. If the failure persists, call for service. 32