Whirlpool WOES5030LB Owners Manual - Page 19

3-Wire Cable from Home Power Supply - U.S. Only IMPORTANT: Use the 3-wire cable from home power supply where local codes permit a 3-wire connection. 4. Securely fasten the oven to the cabinet using the #8-14 x 3/4" (1.9 cm) screws provided. Insert the screws through hole in black trim aligning with hole in oven frame. Do not overtighten screws. A B A. Cable from home power supply F. 4-wire flexible conduit from B. Junction box oven C. Black wires G. Red wires D. White wires H. UL listed wire connectors E. Green (or bare) ground wire I. UL listed or CSA approved (from oven) conduit connector 1. Connect the 2 black wires (C) together using a UL listed wire connector. 2. Connect the 2 white wires (D) and the green (or bare) ground wire (of the oven cable) using a UL listed wire connector. 3. Connect the 2 red wires (G) together using a UL listed wire connector. 4. Install junction box cover. Install Oven 1. Using 2 or more people, lift the oven partially into the cabinet cutout. Use the oven opening as an area to grip. NOTE: Push against seal area of the oven front frame when pushing the oven into the cabinet. Do not push against the outside edges. C A. Oven frame B. Side trim hole C. Side trim piece 5. The bottom vent trim and bottom vent shield are shipped in the foam packing at the top of the oven. Tall bottom vent shield are used when the oven is installed with the feet in the tall position. Please contact service for one to be shipped to you free of charge. � Align vent tab (B) with oven frame (A) as shown. � Using one #8-18 x 3/8" (9.5 mm) screw (C) on each side of the shield tab (B), fasten the vent shield securely to the oven frame (A). 2. Push against the seal area of the front frame to push the oven into the cabinet until the back surface of the front frame touches the front wall of the cabinet. A B C A. Oven frame B. Shield tab C. #8-18 x 3/8" (9.5 mm) screws 3. Push oven completely into the cabinet and center the oven into the cabinet cutout. 19