Yamaha DTXPRESS Reference Guide - Page 13

1-3. Velocity Curve This function sets the MIDI Velocity Curve for the sensitivity for each input jack q. TRIG IN= 1 q VelCurve= normal w q TRIG IN (Trigger Input Number) Assigns the trigger input jack number (the same procedure as in [1-1. Pad Type]). w VelCurve (Velocity Curve) Sets the Input Velocity Curve for the trigger input jack assigned in TRIG IN q. normal loud 2 loud1 hard 1 hard 2 m Velocity Strength of hitm 1-4. Self Rejection, Rejection This function is used to prevent double triggers* and cross talk (mixed input signals between the jacks) for each input jack q. * double trigger: When 2 sounds are played at the same time. TRIG IN= 1 q SelfRej=2 Rej= 3 w e q TRIG IN (Trigger Input Number) Assigns the trigger input jack number (the same procedure as in [1-1. Pad Type]). w SelfRej (Self Rejection) [Range] 0-9 Prevents double triggers from occuring in the input jack assigned in TRIG IN q. After an event is detected, further events will be automatically muted for a certain length of time. Larger values set longer times. e Rej (Rejection) [Range] 0-9 Prevents cross talk from occuring in the input jack assigned in TRIG IN q. Events triggered by other pads (input jacks) that are of a lower input value than what is set here will not be delivered for a set length of time. Trigger Setup Edit Mode 1-5. Specific Rejection This function prevents cross talk from occurring between two specified input jacks q and e. TRIG IN= 1 q SPCRej=0 frm= 1 w e q TRIG IN (Trigger Input Number) Assigns the trigger input jack number (the same procedure as in [1-1. Pad Type]). w SPCRej (Specific Rejection) [Range] 0-9 After an event occurs from the pad from the input jack assigned in e, the pad of the input jack assigned in TRIG IN q will not sound for a certain length of time unless the level is greater than the value assigned here. e frm (Assigned Destination Trigger Input Number) [Range] 1-10, 6&7 Sets the destination trigger input jack number of the pad that will be rejected. When "6&7" is selected, both trigger inputs 6 and 7 will be assigned. 1-6. Trigger Setup Copy This function copies all data settings in [1-1. Pad Type] to [1-5. Specific Rejection] from input jack q to another input jack w. TRIG IN= 1 q Copy to Input= 1 w When the Trigger Setup Copy operation is carried out, the trigger setup data will be replaced with the settings of the copy source. q TRIG IN (Trigger Input Number) Sets the trigger input jack number (1-10) of the pad copy source. w Copy to Input (Trigger Input Number Copy Destination) Sets the trigger input jack number (1-10) of the copy destination. Procedure 1. In the display shown above, assign the copy source and copy destination, press the [SAVE/ENT] button. The following display will appear asking for confirmation before the copy operation is carried out. Input Copy to 1 Are you sure ? 2. Press the [SAVE/ENT] or [VALUE+] button, the copy operation will be carried out. * Press the [VALUE-] button to cancel the copy operation. When the copy operation is complete, "Complete!" will appear. 13