Yamaha DTXPRESS Reference Guide - Page 34

Utility Mode 3-7. Use Tempo This function sets the tempo of a song to either change each time to its default tempo, or remain unchanged at the currently set tempo when the song is switched. UT SEQ SETUP Use Tempo= song q q Use Tempo song: Changes the tempo of the song to its default tempo when the song is switched. global: The tempo remains unchanged at the currently set tempo when the song is switched. 3-8. Click Mode This sets whether or not the click voice will automatically sound during song playback. UT SEQ SETUP ClickMode=manual q q ClickMode (Click Mode) manual: The [CLICK] button will control on/off operation of the click sound. sync: The click will sound during song playback, but will not sound when the song is stopped. The [CLICK] button can also be used to control on/off operation of the click sound. 4. TG (Tone Generator) Group This sub-mode contains settings for the DTXPRESS' tone generator. This group is divided into the following 4 pages. 4-1. Equalizer (EQ 34 4-2. Tuning 34 4-3. Volume 34 4-4. Reverb Bypass 35 4-1. Equalizer (EQ) Sets the Master Equalizer (2-band shelving type). UT TG MASTER EQ Lo=+ 6iHi=+ 0 q w q EQ Lo (Low Gain) [Range] +0 to +12 (dB) w EQ Hi (High Gain) [Range] +0 to +12 (dB) 4-2. Tuning This function sets the master tuning of the tone generator. UT TG MASTER Tune C= 0 F= 0 q w q Tune C (Tune Coarse) [Range] -24 to 0 to +24 Tuning can be set in increments of a half step. w Tune F (Tune Fine) [Range] -64 to 0 to +63 Tuning can be set in increments of about 1.17 cents. 4-3. Volume This function sets the overall volume level of the tone generator. UT TG MASTER Volume= 110 q q Volume [Range] 0-127 34