Yamaha DTXPRESS Reference Guide - Page 33

3-2. Click Tune This sets the pitch for each of the 3 Click Voices. UT SEQ Click= hi q Tune C= 0 F= 0 w e q Click (Click Voice) Selects the Click Voice. (The same Click Voice selected in function 3-1.) w Tune C (Tune Coarse) [Range] -24 to 0 to +24. The Click Voice selected in step q will be tuned in increments of a half-step. e Tune F (Tune Fine) [Range] -64 to 0 to +63. The Click Voice selected in step q will be tuned in increments of about 1.17 cents. 3-3. Click Note Number Sets the MIDI Note Number for each of the 3 Click Voices. UT SEQ Click= hi q Note#= 22 (A#-1) w q Click (Click Voice) Selects the Click Voice. (The same Click Voice selected in function 3-1.) w Note # (MIDI Note Number) [Range] off, 1-127 (-, C#-2 to G8) Sets the MIDI note number. The note number and note name will be displayed. If this is set to "off", the DTXPRESS will produce sound however; key on messages will not be transmitted. * Refer to the preset drum kit's [Drum Voice List] for the voice assignment of each MIDI note number. Utility Mode 3-4. MIDI Control This enables or disables the DTXPRESS to transmit or receive system real-time messages (start/continue/stop). When this function is enabled, you can control an external sequencer or rhythm machine from the DTXPRESS. Control of the DTXPRESS from an external sequencer or rhythm machine is also possible. UT SEQ SETUP MIDI Control=off q q MIDI Control on: Transmits and receives the following system real-time mes- sages. • Transmits timing clock (F8) (transmit only) • Transmits and receives start, stop, and continue (FA, FB, FC) off: Does not transmit or receive system real-time messages. 3-5. Count Switch This function turns the 2 bar countdown before the song starts playback, on or off. UT SEQ SETUP Count Switch=off q q Count Switch on: After a 2 bar countdown, the song will start playback. off: No countdown, the song will start playback immediately. 3-6. Sync Mode This function synchronizes the DTXPRESS sequencer's clock with the clock of an external device. UT SEQ SETUP Sync Mode= auto q q Sync Mode int: Movement is determined by the DTXPRESS' internal clock. ext: Movement is determined by the clock of an external device received via the MIDI IN/TO HOST jacks. auto: If a timing clock (F8) is received via the MIDI IN/TO HOST jack the external clock will be used If a timing clock (F8) is not received the internal clock will be used. 33