Yamaha DTXPRESS Reference Guide - Page 29

Utility Mode 1-5. Hi-Hat Offset This sets the value of the data sent by a foot controller connected to the HI HAT CONTROL jack on the rear panel. Set a + (plus) or - (minus) level. UT SYSTEM HH OffS= 0T= 32 q w q HH OFFS (Hi-Hat Offset) When a low data value is received from the foot controller, the voice will sound sooner. So, slightly pressing the foot controller will result in the voice sounding. In the case of the hi-hat controller, delicate adjustment of the controller's "closed" point is possible. w T (Foot Splash Detect Time) Sets the detect time for the foot splash. Large values make foot splashes easier to produce. * Values too large will result in splashes being produced under normal hi-hat use. 1-6. Factory Set This function replaces all internal settings in the DTXPRESS to their factory-set condition. UT SYSTEM Factory Set The Factory Set function will replace all internal settings in the DTXPRESS to their factory-set condition. Take care so as not to loose important data. Make sure any settings and user songs you want to keep have been saved to an external device such as the Yamaha MIDI Data Filer MDF3, etc. (m[2-1. Bulk Dump] (P. 29) Procedure 1. Enter the display shown above, press the [SAVE/ENT] button. The following display will appear asking for confirmation before the Factory Set operation is carried out. All data will be lost.AreYouSure? 2. Once again, press the [SAVE/ENT] button to proceed with the operation. 2. MIDI Group This sub-mode contains functions and settings for the MIDI and TO HOST jacks of the DTXPRESS. This group is divided into the following 10 pages. 2-1. Bulk Dump 29 2-2. Channel 10 Program Change/ Channel Event Receive 30 2-3. Receive Program Change/ System Exclusive Messages 30 2-4. Program Change Table 31 2-5. MIDI Mode 31 2-6. Device Number, Local Control 31 2-7. MIDI Merge 31 2-8. Dump Interval 32 2-9. Send Hi-Hat Control 32 2-10. Host Thru Port 32 * Please refer to the [MIDI Data Format] (P. 50) section for more information related to MIDI. 2-1. Bulk Dump With the Bulk Dump operation, data stored in the ETXPRESS can be transmitted via the MIDI OUT or TO HOST jack. UT MIDI BULKDUMP Fmt= all data q q Fmt (Bulk Dump Format) Selects the type of data to be transmitted with the Bulk Dump operation. all data : All the data in the DTXPRESS system data : Data set in the Utility mode (except User Map). user map : User Map data. one drumkit : Data for the currently selected Drum Kit. all drumkit : All User Drum Kit Data. one trigger : Data for the currently selected Trigger Setup. all trigger : All User Trigger Setup data one song : Data for the currently selected User Song. all song : All User Song data. Procedure 1. After reading the [Connecting a MIDI Device] (Basic Guide : P. 12) or the [Connecting a Computer] (Basic Guide : P. 26) section, connect the external MIDI device or computer to the MIDI OUT or TO HOST jack on the DTXPRESS. Set the HOST SELECT switch. 29