Yamaha DTXPRESS Reference Guide - Page 31

2-4. Program Change Table Use this function to create a program change table (a list of program change numbers that correspond to drum kits). A program change message received internally from the DTXPRESS or through channel 10 from an external MIDI device will select, according to the program change table, the drum kit corresponding to the kit number in the DTXPRESS. UT MIDI PC TABLE No= 1-> kit 56 q w q No (Program Change Number) Sets the program change number (1-128). When the program change number set in this parameter is received, the corresponding drum kit number that is set in the following "kit" parameter will be selected. w kit (Drum Kit Number) Sets the drum kit number (1-80). If this parameter is set to "none" the DTXPRESS will not respond, even when a program change message is received. * When the drum kit is changed with the DTXPRESS, the program change set in this function will be transmitted through MIDI channel 10. However, when a program change number is not assigned, it will not transmit. * When the following [2-5. MIDI Mode] is set to GM, receiving program changes will be limited. 2-5. MIDI Mode This sub-group contains settings related to the MIDI IN jack and TO HOST input jack that affect tone generator events. UT MIDI SETUP MIDI Mode=native q q MIDI Mode native: Recognizes all program changes for the drum voice. GM: Drum voice pan is reversed so you will hear the drums as if your are sitting in the audience, the hi-hat will be heard on the right side. The following drum voice pro- gram changes are recognized. 1, 2, 9, 17, 25, 26, 33, 41, 50 Utility Mode 2-6. Device Number, Local Control Sets the MIDI device number and local control. UT MIDI SETUP DevNo=ALLocl= on q w q DevNo (Device Number) Sets the MIDI device number (1-16). Bulk dumps will be transmitted with this device number. Only data corresponding to this device number will be recognized when received. If this is set to "AL", the device number will be "1" for transmitting data and data will be received from all device numbers. w Locl (Local Control) Switches Local Control ON or OFF. off: MIDI signals triggered by the connected pads is disconnected from the DTXPRESS' tone generator, there will be no sound produced by the DTXPRESS' tone generator. The DTXPRESS will transmit MIDI signals from the MIDI OUT jack and TO HOST jack. on: Normal operation. MIDI signals will be transmitted to the DTXPRESS' tone generator as well as the MIDI OUT and TO HOST jacks. 2-7. MIDI Merge Sets the MIDI Merge function ON or OFF. When this function is ON, data received from an external MIDI device connected to the MIDI IN jack will be mixed with internal MIDI data from the DTXPRESS and transmitted from the DTXPRESS' MIDI OUT jack. UT MIDI SETUP Merge Output=off q q Merge Output (Merge Out) on: Sends signals to the MIDI OUT jack. off: Does not send signal to the MIDI OUT jack (internal opera- tion only). Normal operation. Connecting the MIDI IN/OUT jacks on a single device and setting MIDI Merge to "on" will result in a signal loop that may cause notes to sound (play) continuously. 31