Yamaha LS9-32 Ls9 Editor Owner's Manual - Page 37
If a MIX channel is selected, CHANNEL SELECT Channel selection, TO MATRIX
View all Yamaha LS9-32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
If a MIX channel is selected ❏ CHANNEL SELECT (Channel selection) 1 2 A SELECT (Channel selection) Except for the fact that your editing applies to a MIX channel, this is the same as the channel selection for an input channel (➥ p.27). B OUTPUT PATCH This selects the output port that will be assigned to the MIX channel. (For the output ports that can be selected (➥ p.18). If multiple patches have been made, only the first port is shown. If you change the patching in this window, the port that had been assigned until then will be cancelled, and only the newly selected port will be assigned. ❏ TO MATRIX A MATRIX send level 1 This adjusts the send level of the signal sent from the MIX channel to the MATRIX 2 buses. 3 B ON (MATRIX send on/off) This is an on/off switch for the signal sent from the MIX channel to the MATRIX bus. C POINT (Send point) Select either PRE or POST as the position from which the signal is sent from the MIX channel to the MATRIX bus. PRE POINT is selected if this is on, or POST FADER is selected if this is off. The PRE POINT setting can be made in the Mixer Setup screen. HINT • If you are using MATRIX buses in stereo, the knob for the odd-numbered bus will be PAN. Knob of oddnumbered side • The stereo/mono status can be specified in the Mixer Setup screen. 37 LS9 Editor Owner's Manual