Yamaha MOXF8 Reference Manual - Page 59
Performance Edit, Common Edit
View all Yamaha MOXF8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
VOICE PERF SONG PATTERN MIX MASTER REMOTE UTILITY QUICK SET FILE Performance Edit Each performance can contain a maximum of four Parts. There are two types of Performance Edit displays: those for Common Edit to edit the settings common to all four Parts, and those for Part Edit to edit the individual Parts. This section explains the parameters for Common Edit and Part Edit. Common Edit Operation [PERFORM] Performance selection [EDIT] [COMMON] [F1] GENERAL [SF1] NAME From this display you can assign the category (sub and main) of the selected Performance, and create a name for the Performance. The Performance name can contain up to 20 characters. For detailed instructions on naming, see the "Basic Operation" of the Owner's Manual. [SF2] PLY MODE (Play Mode) SplitPoint Determines the note number of the Split point, which divides the keyboard into two different sections. Settings: C#-2 - G8 NOTE When the "SplitLo/Up" parameter of each Part is set to "both," this parameter will have no effect. NOTE Sound is produced only when you play notes within the area that matches both the Split setting and Note Limit setting. NOTE You can also set the note directly from the keyboard, by holding down the [SF6] KBD button and pressing the desired key. SplitSwitch Determines whether the settings of the Split Point and the Split Lower/Upper position in the Part parameter are enabled (on) or disabled (off). Settings: off, on [SF3] EQ OFS (EQ Offset) This is a parametric EQ featuring three bands (High, Mid and Low). You can attenuate or boost the level of each frequency band (High, Mid, Low) to change the Voice sound. Determines the offset value for the same parameters in the [F3] EQ display (page 67). FREQ (Frequency) Determines the frequency for each frequency band. GAIN Determines the level gain for the Frequency (above), or the amount the selected frequency band is attenuated or boosted. The higher the value, the greater the Gain. The lower the value, the lesser the Gain. Q Determines the Q (bandwidth) for the Mid band. The higher the value, the smaller the bandwidth. The lower the value, the wider the bandwidth. Settings: -64 - +0 - +63 Performance Mode Performance Play [F1] PLAY [F2] VOICE [F3] PORTA [F4] EG [F5] ARP ED [F6] EFFECT Arpeggio Edit [F1] COMMON [F2] TYPE [F3] MAIN [F4] LIMIT [F5] PLAY FX [F6] OUT CH Performance Edit Common Edit [F1] GENERAL [F2] OUT/MFX [F3] MEQ [F4] USB I/O [F5] A/D IN [F6] EFFECT Part Edit [F1] VOICE [F2] OUTPUT [F3] EQ [F4] TONE [F5] RCV SW Performance Job [F1] INIT [F2] RECALL [F3] COPY [F4] BULK Performance Record [F1] SETUP [F2] REC TR [F3] OTHER [F5] CLICK [F6] INFO Supplementary Information [SF4] PORTA (Portamento) This display allows you to set the Portamento-related parameters. The parameters are the same as in Performance Play. See page 56. MOXF6/MOXF8 Reference Manual 59