ZyXEL MGS-3712F User Guide - Page 271
Configuring Layer 2 Protocol Tunneling
View all ZyXEL MGS-3712F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 271 highlights
Chapter 29 Layer 2 Protocol Tunneling 29.2 Configuring Layer 2 Protocol Tunneling Click Advanced Application > Layer 2 Protocol Tunneling in the navigation panel to display the screen as shown. Figure 146 Advanced Application > Layer 2 Protocol Tunneling The following table describes the labels in this screen. Table 89 Advanced Application > Layer 2 Protocol Tunneling LABEL DESCRIPTION Active Select this to enable layer 2 protocol tunneling on the Switch. Destination MAC Address Specify an MAC address with which the Switch uses to encapsulate the layer 2 protocol packets by replacing the destination MAC address in the packets. Note: The MAC address can be either a unicast MAC address or multicast MAC address. If you use a unicast MAC address, make sure the MAC address does not exist in the address table of a switch on the service provider's network. Note: All the edge switches in the service provider's network should be set to use the same MAC address for encapsulation. Port This field displays the port number. MGS-3712/MGS-3712F User's Guide 271