ZyXEL MGS-3712F User Guide - Page 63

Chapter 5 The Web Configurator 2 Delete all port-based VLANs with the CPU port as a member. The "CPU port" is the management port of the Switch. 3 Filter all traffic to the CPU port. 4 Disable all ports. 5 Misconfigure the text configuration file. 6 Forget the password and/or IP address. 7 Prevent all services from accessing the Switch. 8 Change a service port number but forget it. Note: Be careful not to lock yourself and others out of the Switch. If you do lock yourself out, try using out-of-band management (via the management port) to configure the Switch. 5.6 Resetting the Switch If you lock yourself (and others) from the Switch or forget the administrator password, you will need to reload the factory-default configuration file or reset the Switch back to the factory defaults. 5.6.1 Reload the Configuration File Uploading the factory-default configuration file replaces the current configuration file with the factory-default configuration file. This means that you will lose all previous configurations and the speed of the console port will be reset to the default of 9600bps with 8 data bit, no parity, one stop bit and flow control set to none. The password will also be reset to "1234" and the IP address to 192.168.1.1. To upload the configuration file, do the following: 1 Connect to the console port using a computer with terminal emulation software. 2 Disconnect and reconnect the Switch's power to begin a session. When you reconnect the Switch's power, you will see the initial screen. 3 When you see the message "Press any key to enter Debug Mode within 3 seconds ..." press any key to enter debug mode. 4 Type atlc after the "Enter Debug Mode" message. MGS-3712/MGS-3712F User's Guide 63