2008 BMW M6 Owner's Manual - Page 219

procedures with correspondingly trained personnel. Due to the high voltage involved, there is a danger to life and limb when work is carried out improperly.< 2. Turn the bulb holder to the left by 90 5 and remove. 3. Remove and replace the bulb. Parking lamps, roadside parking lamps, daytime running lamps Tail lamps The parking lamps, tail lamps, brake lamps, and turn signals use LED technology. The backup lamps are equipped with longlife bulbs. Please contact a BMW center in case of a malfunction.< The illustration shows the front left side of the engine compartment. 35-watt bulb, H 8 1. Remove the cover cap 1 by pressing the tab and removing the cover cap upward. 2. Turn the bulb holder to the left and remove. 3. Remove and replace the bulb. Always wear gloves and eye protection - the atmosphere inside the H8 bulb is pressurized. Otherwise, there is a danger of injuries if the bulb is accidentally damaged during replacement.< 1 2 3 4 Turn signals Roadside parking, tail and brake lamp Reflector Backup lamp License plate lamps Side-mounted turn signals 5-watt bulb, WY5W 1. Press against the front edge of the lamp with the tip of your finger, then push it to the rear, release the snap connection at the front and take it off the trim strip. 5-watt bulb, W5W 1. Push a screwdriver from the left under the lamp and pry out the lamp toward the right. 3. Remove and replace the bulb. 217 Online Edition for Part no. 01 41 0 014 244 - © 08/07 BMW AG Reference Mobility 2. Turn the bulb holder to the left by 90 5 and remove. Communications Entertainment Navigation Driving tips Controls At a glance