2008 BMW M6 Owner's Manual - Page 78

Everything under control Displays after completion of trip Malfunction reports generated during the trip are shown consecutively when you switch off the ignition. Before the display disappears, you can display the messages once again. Press the CHECK button for approx. 2 seconds. If several messages are present, you can press the CHECK button repeatedly. 6. Select a message and press the controller. The display: > turns off automatically after a brief period > can be turned off at any time by pressing the CHECK button again for approx. 2 seconds Speed limit To exit from the menu immediately: Select the arrow and press the controller. You can enter a speed and a Check Control message indicates when you have reached this speed. This enables you, for example, to receive warnings if you exceed a speed limit in an urban area. You are only warned of reaching this speed a second time if your vehicle speed falls below it again by at least 3 mph/5 km/h. Displaying the urgency of malfunctions Displaying, setting or changing limit iDrive, for operating principle refer to page 16. 1. Open the start menu. 2. Open "Navigation". Without navigation system*: open "Car Data". Depending on the equipment, the stored Check Control messages are also displayed with the following symbols: No malfunctions detected in the monitored systems. Malfunctions detected in the monitored systems. Depending on the malfunction, supplementary information is shown on the Control Display. The symbols also indicate the status of the service requirements display, refer to page 72. 3. Select "Car Data" and press the controller. 4. Select "Limit" and press the controller. 76 Online Edition for Part no. 01 41 0 014 244 - © 08/07 BMW AG