1997 Chevrolet Cavalier Owner's Manual - Page 154
1997 Chevrolet Cavalier Manual
Page 154 highlights
RECALL: Press this button to recall the station being played. If you press the button when the ignition is off, the clock will show a few seconds. for SCV: Your system has a feature called Speed-Compensated-Volume (SCV). With SCV, your audio system adjusts automatically make upfor road to and wind noise as you drive. the volume at the Set desired level. Move the control ring behind the upper knob clockwiseto adjust the SCV. Then, as you drive, SCV automatically increases the volume, as necessary, to overcome noise at any particular speed. The volume level should always sound the same you as you drive. to If you don't want to use SCV, turn the control all the way down. Each detent onthe control ring allows for more volume compensation at a faster rate of speed. SCAN: Press oneof the SEEK arrowsfor two seconds, and SCAN will appear on the display. Use SCAN to listen to stationsfor a few seconds.The radio will go to a station, stop for a few seconds, then on to the next go station. Press SEEK again to stop scanning. The sound will mute while scanning. PUSHBUTTONS: The six numbered pushbuttons let you return to your favorite stations.You can set up to 18 stations (six AM, six FM1 and six FM2). Just: 1. Turn the radio on. 2. Press AM-FM to select the band. 3. Tune in the desired station. 4. Press AUTOTONE to select the equalization that best suits the type of station selected. 5. Press and holdone of the six numbered buttons.The Finding a StYion AM-FM: Press this buttonto switch between AM,FMl and FM2. The display shows your selection. TUNE: Press this knob lightly so it extends. Turnit to choose radio stations. Push the knob back into its stored position when you're not using it. SEEK: Press the rightor left arrow to go to the next higher or lower station and stay there. sound will The mute while seeking. sound will mute. When returns, release the button. it Whenever you press that numbered button, the station you set will return and the AUTO TONE equalization that you selected will also be automatically selected for that button. for 6. Repeat the steps each pushbutton.