2011 Chevrolet Equinox Owner's Manual - Page 262

9-40 Driving and Operating TCS is on whenever the vehicle is started. To limit wheel spin, especially in slippery road conditions, the system should always be left on. But, TCS can be turned off if needed. When this message is displayed and d comes on and stays on, the vehicle is safe to drive but the system is not operational. Driving should be adjusted accordingly. Notice: Do not repeatedly brake or accelerate heavily when TCS is off. The vehicle's driveline could be damaged. If d comes on and stays on, reset the system by: Ride Control Systems Traction Control System (TCS) The vehicle has a Traction Control System (TCS) that limits wheel spin. On a front-wheel-drive vehicle, the system operates if it senses that one or both of the front wheels are spinning or beginning to lose traction. On an All-Wheel-Drive (AWD) vehicle, the system will operate if it senses that any of the wheels are spinning or beginning to lose traction. When this happens, the system brakes the spinning wheel(s) and/or reduces engine power to limit wheel spin. The system may be heard or felt while it is working, but this is normal. d flashes to indicate that the traction control system is active. If there is a problem detected with TCS, SERVICE TRACTION CONTROL and SERVICE STABILITRAK may be displayed on the Driver Information Center (DIC) and d will be on. See Ride Control System Messages on page 5‑27. 1. Stopping the vehicle. 2. Turning the engine off and waiting 15 seconds. 3. Starting the engine. If d still comes on and stays on at a speed above 20 km/h (13 mph), see your dealer for service. A chime may also sound when the light comes on steady. The g is located on the console.