2011 Chevrolet Equinox Owner's Manual - Page 320

10-34 Vehicle Care 3. If replacing low/high headlamp bulb, remove the dust cover cap from the back of the headlamp housing by turning the cap counterclockwise. 4. Turn the bulb socket counterclockwise to remove from lamp assembly. 5. Remove the bulb from the socket or disconnect bulb assembly from harness connector. 6. Install new bulb. 7. Reinstall the lamp socket to lamp assembly turning clockwise. 8. Replace the dust cover cap on headlamps. 9. Reinstall the wheel well cover access port cap and secure by installing screw. Fog Lamps To replace one of these bulbs: 4. Push the bulb socket into the fog lamp assembly and turn clockwise to lock it into place. 5. Reconnect the bulb socket to the electrical connector. Taillamps, Turn Signal, Sidemarker, Stoplamps, and Back-Up Lamps 1. Locate the fog lamp assembly under the front facia. 2. Disconnect the bulb socket from the electrical connector, turn and pull out the bulb assembly. 3. Remove the old bulb from the bulb socket and push the new bulb straight into the bulb socket until it connects. A. Sidemarker B. Stoplamp/Turn Signal Lamp/ Taillamp C. Back-up Lamp