2011 Chevrolet Equinox Owner's Manual - Page 39

Keys, Doors and Windows Vehicles with an automatic climate control system will default to a heating or cooling mode depending on the outside temperature during a remote start. Once the key is turned to ON/RUN, the system will turn on at the setting the vehicle was last set to. If the vehicle has heated seats, they may come on during a remote start. See Heated Front Seats on page 3‑8 for more information. Laws in some local communities may restrict the use of remote starters. For example, some laws require a person using remote start to have the vehicle in view. Check local regulations for any requirements. There are other conditions which can affect the performance of the transmitter. See Remote Keyless Entry (RKE) System on page 2‑3 for additional information. Starting the Engine Using Remote Start To start the engine using the remote start feature: 1. Press 2-5 When the remote start is extended, the second 10 minutes will start immediately. For example, if the engine has been running for 5 minutes, and 10 minutes are added, the engine will run for a total of 15 minutes. A maximum of two remote starts or remote start attempts are allowed between ignition cycles. The vehicle's ignition switch must be turned to ON/RUN and then back to LOCK/OFF using the key, before the remote start procedure can be used again. Shutting the Engine Off After a Remote Start To shut off the engine: . Q on the RKE transmitter. 2. Press and hold / for about two seconds. The turn signal lamps will briefly flash to confirm the vehicle has been started. The parking lamps will turn on and remain on as long as the engine is running. The vehicle's doors will be locked. 3. The key must be inserted and turned to ON/RUN before driving. The engine will shut off after 10 minutes unless a time extension is done or the key is inserted and turned to ON/RUN. Extending Engine Run Time For a 10-minute extension, repeat Steps 1 and 2 while the engine is still running. The remote start can be extended once. Press / until the parking lamps turn off. Turn on the hazard warning flashers. Insert the key and turn it to ON/RUN and then back to LOCK/OFF. . .