2011 Chevrolet Equinox Owner's Manual - Page 264

9-42 Driving and Operating pedal. This is normal. Continue to steer the vehicle in the intended direction. If there is a problem detected with StabiliTrak, SERVICE STABILITRAK is displayed on the Driver Information Center (DIC) and d will stay on. See Vehicle Messages on page 5‑23. When this message is displayed and/or d comes on and stays on, the vehicle is safe to drive but the system is not operational. Driving should be adjusted accordingly. See Ride Control System Messages on page 5‑27. If d comes on and stays on, reset the system by: 1. Stopping the vehicle. 2. Turning the engine off and waiting 15 seconds. 3. Starting the engine. If d still comes on and stays on at a speed above 20 km/h (13 mph), see your dealer for service. Cruise Control With cruise control, the vehicle can maintain a speed of about 40 km/h (25 mph) or more without keeping your foot on the accelerator. Cruise control does not work at speeds below 40 km/h (25 mph). If the brakes are applied, the cruise control is disengaged. If the vehicle has the StabiliTrak® system and begins to limit wheel spin while using cruise control, the cruise control automatically disengages. See StabiliTrak® System on page 9‑41 or Traction Control System (TCS) on page 9‑40. When road conditions allow you to safely use it again, the cruise control can be turned back on. g is located on the console. Both StabiliTrak and Traction Control can be turned off if needed by pressing and holding g until g and i come on the instrument panel. When StabiliTrak is turned off, the system will not assist with directional control of the vehicle or limit wheel spin. Driving should be adjusted accordingly. Press and release g again to turn the system back on. If cruise control is being used when StabiliTrak activates, the cruise control will automatically disengage. Press the cruise control button to reengage when road conditions allow. See Cruise Control on page 9‑42 for more information.