2013 Chevrolet Avalanche Owner Manual - Page 307
2013 Chevrolet Avalanche Manual
Page 307 highlights
Driving and Operating Using Cruise Control on Hills How well the cruise control works on hills depends on the vehicle speed, the load, and the steepness of the hills. When going up steep hills, pressing the accelerator pedal may be necessary to maintain vehicle speed. When going downhill, Cruise Grade Braking helps maintain the driver selected speed. Cruise Grade Braking is enabled when the vehicle is started and Cruise Control is active. It is not enabled in Range Selection Mode. It assists in maintaining driver selected speed when driving on downhill grades by using the engine and transmission to slow the vehicle. To disable and enable Cruise Grade Braking for the current ignition key cycle, press and hold the Tow/Haul button for three seconds. A DIC message displays. See Transmission Messages on page 5‑42. For other forms of Grade Braking, see Automatic Transmission on page 9‑29 andTow/Haul Mode on page 9‑33. Ending Cruise Control There are three ways to end cruise control: . 9-49 Object Detection Systems Ultrasonic Parking Assist If available, the Ultrasonic Rear Parking Assist (URPA) system assists the driver with parking and avoiding objects while in R (Reverse). URPA operates at speeds less than 8 km/h (5 mph). The sensors on the rear bumper detect objects up to 2.5 m (8 ft) behind the vehicle, and at least 25 cm (10 in) off the ground. To disengage cruise control, step lightly on the brake pedal. Press the wheel. . [ on the steering . To turn off the cruise control, press I on the steering wheel. Erasing Speed Memory The cruise control set speed is erased from memory by pressing the I button or if the ignition is turned off.