2013 Chevrolet Avalanche Owner Manual - Page 350
2013 Chevrolet Avalanche Manual
Page 350 highlights
10-16 Vehicle Care coolant for the cooling system. See Recommended Fluids and Lubricants on page 11‑12. Never dispose of engine coolant by putting it in the trash, pouring it on the ground, or into sewers, streams, or bodies of water. Have the coolant changed by an authorized service center, familiar with legal requirements regarding used coolant disposal. This will help protect the environment and your health. coolant surge tank, but be sure the cooling system is cool before this is done. Use a 50/50 mixture of clean, drinkable water and DEX-COOL coolant. If using this mixture, nothing else needs to be added. This mixture: . Gives freezing protection down to −37°C (−34°F), outside temperature. Gives boiling protection up to 129°C (265°F), engine temperature. Protects against rust and corrosion. Will not damage aluminum parts. Helps keep the proper engine temperature. . . . . Checking Coolant The vehicle must be on a level surface when checking the coolant level. Check to see if coolant is visible in the coolant surge tank. If the coolant inside the coolant surge tank is boiling, do not do anything else until it cools down. If coolant is visible but the coolant level is not at or above the FULL COLD mark, add a 50/50 mixture of clean, drinkable water and DEX-COOL coolant at the The coolant surge tank is located in the engine compartment on the passenger side of the vehicle. See Engine Compartment Overview on page 10‑5 for more information on location. The coolant level should be at or above the FULL COLD mark. If it is not, the vehicle may have a leak in the cooling system. Notice: If improper coolant mixture, inhibitors, or additives are used in the vehicle cooling system, the engine could overheat and be damaged. Too much water in the mixture can freeze and crack engine cooling parts. The repairs would not be covered by the warranty. Use only the proper mixture of engine