2013 Chevrolet Malibu Owner Manual - Page 292

10-26 Vehicle Care High-Beam Headlamp 1. For the driver side bulb, remove the windshield washer bottle filler neck by firmly pulling it straight up and out of the bottle. 2. Remove the cap from the back of the headlamp assembly by turning it counterclockwise. 4. Disengage the spring clip (B) from the bulb by pressing down on the end and then swing upward. 5. Remove the bulb from the lamp assembly. 6. Install a new bulb in the lamp assembly. 7. Install the spring clip (B). 8. Connect the electrical connector (A). Headlamps, Front Turn Signal, Sidemarker, and Parking Lamps Passenger Side Shown, Driver Side Similar A. High-Beam Headlamp B. Turn Signal Lamps C. Low-Beam Headlamp D. Parking Lamp E. Sidemarker Lamp 3. Disconnect the electrical connector (A). 9. Replace the cap from the back of the headlamp assembly by turning it clockwise. 10. For the driver side, reinstall the windshield washer bottle filler neck by firmly pushing it straight into the bottle. Ensure that the filler neck clip engages into the underhood electrical center retainer.