2013 Chevrolet Malibu Owner Manual - Page 62

3-12 Seats and Restraints To raise a seatback: 1. Lift the seatback up and push it rearward to lock it in place. Make sure the safety belt is in the belt guide and is not twisted or caught in the seatback. A tab near the seatback lever retracts when the seatback is locked in place. The center rear safety belt may lock when you raise the seatback. If this happens, let the belt go back all the way and start again. 2. Push and pull the top of the seatback to be sure it is locked into position. 3. Repeat Steps 1 and 2 for the other seatback, if necessary. When the seat is not in use, it should be kept in the upright, locked position. Raising the Seatback Rear Seat Armrest { WARNING If either seatback is not locked, it could move forward in a sudden stop or crash. That could cause injury to the person sitting there. Always push and pull on the seatbacks to be sure they are locked. { WARNING A safety belt that is improperly routed, not properly attached, or twisted will not provide the protection needed in a crash. The person wearing the belt could be seriously injured. After raising the rear seatback, always check to be sure that the safety belts are properly routed and attached, and are not twisted. The rear seat has an armrest in the center of the seatback. Lower the armrest to access the two cupholders and the storage area. To fold, lift the armrest up and push it rearward until it is flush with the seatback.