2014 Chevrolet Camaro Owner Manual - Page 244

9-48 Driving and Operating Warning (Continued) previous screen after approximately 4 seconds once the vehicle is shifted out of R (Reverse). To see the previous screen sooner, do one of the following: . Symbols and Guidelines The RVC system may have a feature that lets the driver view symbols on the infotainment screen while using the RVC. The Ultrasonic Rear Park Assist (URPA) system must not be disabled to use the caution symbols. The error message Rear Parking Assist Symbols Unavailable may display if URPA has been disabled and the symbols have been turned on. See Ultrasonic Parking Assist on page 9-46. The symbols appear and may cover an object when viewing the infotainment screen when an object is detected by the URPA system. The RVC system may also have a guideline overlay that can help the driver align the vehicle when backing into a parking spot. To turn the symbols or guidelines on or off: 1. Shift into P (Park). 2. Press the CONFIG button. of view, below the bumper, or under the vehicle. Perceived distances may be different from actual distances. Do not back the vehicle using only the RVC screen, during longer, higher speed backing maneuvers, or where there could be cross traffic. Failure to use proper care before backing may result in injury, death, or vehicle damage. Always check behind and around the vehicle before backing. The RVC system is designed to help the driver when backing up by displaying a view of the area behind the vehicle. When the key is in ON/ RUN and the driver shifts the vehicle into R (Reverse), the video image automatically appears on the infotainment screen. The infotainment screen goes to the Press a hard key on the infotainment system. Shift into P (Park). Reach a vehicle speed of 8 km/h (5 mph). . . Turning the Rear Vision Camera System On or Off To turn the rear vision camera system on or off: 1. Shift into P (Park). 2. Press the CONFIG button. 3. Select Rear Camera Options. 4. Select Camera. When a check mark appears next to the Camera option, then the RVC system is on.