2014 Chevrolet Camaro Owner Manual - Page 330

10-74 Vehicle Care 1. Remove the tire sealant canister (4) and compressor from its storage location. See Storing the Tire Sealant and Compressor Kit on page 10-79. 2. Remove the air only hose (10) and the power plug (9) from the bottom of the compressor. 3. Place the compressor on the ground near the flat tire. 5. Slide the base of the tire sealant canister (3) into the slot on the top of the compressor (6) to hold it upright. Make sure the tire valve stem is positioned close to the ground so the hose will reach it. 6. Remove the valve stem cap from the flat tire by turning it counterclockwise. 4. Attach the air only hose (10) to the sealant canister inlet valve (1) by turning it clockwise until tight. There is only enough sealant to seal one tire. After usage, the tire sealant canister must be replaced. Using the Tire Sealant and Compressor Kit to Temporarily Seal and Inflate a Punctured Tire When using the tire sealant and compressor kit during cold temperatures, warm the kit in a heated environment for five minutes. This will help to inflate the tire faster. If a tire goes flat, avoid further tire and wheel damage by driving slowly to a level place. Turn on the hazard warning flashers. See Hazard Warning Flashers on page 6-4. See If a Tire Goes Flat on page 10-70 for other important safety warnings. Do not remove any objects that have penetrated the tire.