2014 Chevrolet Camaro Owner Manual - Page 30
2014 Chevrolet Camaro Manual
Page 30 highlights
2-4 Keys, Doors, and Windows The buttons on the keys are disabled when there is a key in the ignition. 3. Insert the new key to be programmed and turn it to the ON/RUN position within five seconds. The security light will turn off once the key has been programmed. 4. Repeat Steps 1-3 if additional keys are to be programmed. If a key is lost or damaged, see your dealer to have a new key made. Programming without a Recognized Transmitter Program a new key to the vehicle when a recognized key is not available. Canadian regulations require that owners see their dealer. If there are no currently recognized keys available, follow this procedure to program the first key. This procedure will take approximately 30 minutes to complete for the first key. The Pressing K will disarm the theft-deterrent system. See Vehicle Alarm System on page 2-11. V or Y (Remote Trunk Release): Press and hold to open the trunk. Programming Transmitters to the Vehicle Only RKE transmitters programmed to this vehicle will work. If a transmitter is lost or stolen, a replacement can be purchased and programmed through your dealer. When the replacement transmitter is programmed to this vehicle, all remaining transmitters must also be reprogrammed. Any lost or stolen transmitters will no longer work once the new transmitter is programmed. Programming with a Recognized Transmitter To program a new key: 1. Insert the original, already programmed key in the ignition and turn to the key to the ON/ RUN position. 2. Turn the key to LOCK/OFF, and remove the key. 7 (Vehicle Locator/Panic Alarm): Press and release to initiate vehicle locator. The exterior lamps flash and the horn chirps three times. Press and hold 7 for at least three seconds to sound the panic alarm. The horn sounds and the turn signals flash until 7 is pressed again or the key is placed in the ignition and turned to ON/RUN. / (Remote Vehicle Start): If equipped, press and release Q and then immediately press and hold/ for at least four seconds to start the engine from outside the vehicle using the RKE transmitter. See Remote Vehicle Start on page 2-5.