2014 Chevrolet Camaro Owner Manual - Page 332

10-76 Vehicle Care 13. Unplug the power plug (9) from the accessory power outlet in the vehicle. 14. Turn the sealant/air hose (2) counterclockwise to remove it from the tire valve stem. 15. Replace the tire valve stem cap. 16. Remove the tire sealant canister (4) from the slot on top of the compressor (6). 17. Turn the air only hose (10) counterclockwise to remove it from the tire sealant canister inlet valve (1). 18. Turn the sealant/air hose (2) clockwise onto the sealant canister inlet valve (1) to prevent sealant leakage. 19. Return the air only hose (10) and power plug (9) back to their original storage location. 20. If the flat tire was able to inflate to the recommended inflation pressure, remove the maximum speed label from the sealant canister and place it in a highly visible location. Do not exceed the speed on this label until the damaged tire is repaired or replaced. 21. Return the equipment to its original storage location in the vehicle. 22. Immediately drive the vehicle 8 km (5 mi) to distribute the sealant in the tire. Caution (Continued) farther. The tire is too severely damaged and the tire sealant and compressor kit cannot inflate the tire. Remove the power plug from the accessory power outlet and unscrew the inflating hose from the tire valve. See Roadside Assistance Program on page 13-5. 12. Press the on/off button (5) to turn the tire sealant and compressor kit off. The tire is not sealed and will continue to leak air until the vehicle is driven and the sealant is distributed in the tire. Therefore, Steps 13-21 must be done immediately after Step 12. Be careful while handling the tire sealant and compressor kit as it could be warm after usage.