2014 Chevrolet Traverse Owner Manual - Page 253
2014 Chevrolet Traverse Manual
Page 253 highlights
Driving and Operating 9-15 Starting and Operating New Vehicle Break-In Caution (Continued) breaking-in guideline every time you get new brake linings. Following break-in, engine speed and load can be gradually increased. In order to shift out of P (Park), the ignition must be in ON/RUN or ACC/ ACCESSORY and the brake pedal must be applied. { Caution The vehicle does not need an elaborate break-in. But it will perform better in the long run if you follow these guidelines: . { Caution Using a tool to force the key to turn in the ignition could cause damage to the switch or break the key. Use the correct key, make sure it is all the way in, and turn it only with your hand. If the key cannot be turned by hand, see your dealer. Ignition Positions Do not drive at any one constant speed, fast or slow, for the first 805 km (500 mi). Do not make full-throttle starts. Avoid downshifting to brake or slow the vehicle. Avoid making hard stops for the first 322 km (200 mi) or so. During this time the new brake linings are not yet broken in. Hard stops with new linings can mean premature wear and earlier replacement. Follow this (Continued) ( (STOPPING THE ENGINE/ LOCK/OFF): When the vehicle is stopped, turn the ignition switch to LOCK/OFF to turn the engine off. Retained Accessory Power (RAP) will remain active. See Retained Accessory Power (RAP) on page 9-19. The ignition switch has four different positions. .