2014 Chevrolet Traverse Owner Manual - Page 360

10-66 Vehicle Care Storing the Tools 3. Turn the jack (3) on its side and place down on the holding bracket. 4. Reinstall the wing bolt (2) by turning clockwise. 5. To replace the cover, line up the tab at the front of the cover with the notch in the cover opening. Push the cover in place and make sure that the rear clips are in the slots and push the cover closed. 1. Tool Bag Store the center cap or the plastic bolt-on wheel covers until a full size tire is put back on the vehicle. When you replace the compact spare with a full-size tire, reinstall the bolt-on wheel covers or the center cap. Hand-tighten them over the wheel nuts, using the wrench. 7. Pull on the cable to make sure it is secure. 8. Make sure the metal tube is centered at the striker. Push the tube toward the front of the vehicle. 9. Close the liftgate and make sure it is latched properly. 2. Wing Bolt 3. Jack Put back all tools as they were stored in the jack storage compartment and put the compartment cover back on. 1. Ensure that the bottom of the jack is facing toward you. 2. Replace the tool bag (1).