2014 Chevrolet Traverse Owner Manual - Page 37
2014 Chevrolet Traverse Manual
Page 37 highlights
Keys, Doors, and Windows Starting the Engine Using Remote Start To start the vehicle: 1. Aim the RKE transmitter at the vehicle. 2. Press and release RKE transmitter. during colder outside temperatures and shut off when the key is turned to ON/RUN. See Heated and Cooled Front Seats on page 3-8. The rear window defogger and heated mirrors, if the vehicle has them, turn on during colder outside temperatures and turn off when the key is turned to ON/RUN. After entering the vehicle during a remote start, insert and turn the key to the ON/RUN position to drive the vehicle. If the vehicle is left running it automatically shuts off after 10 minutes unless a time extension has been done. 2-5 If the remote start procedure is used again before the first 10-minute time frame has ended, the first 10 minutes will immediately expire and the second 10-minute time frame will start. For example, if Q and then / are pressed again after the vehicle has been running for five minutes, 10 minutes are added, allowing the engine to run for a total of 15 minutes. A maximum of two remote starts or remote start attempts are allowed between ignition cycles. After the vehicle's engine has been started two times using the remote start button, the ignition must be turned on and then back off before the remote start procedure can be used again. Q on the 3. Immediately after completing Step 2, press and hold / until the parking lamps flash. If the vehicle's lights cannot be seen, press and hold / for at least four seconds. When the vehicle starts, the parking lamps will turn on and remain on as long as the engine is running. The doors will be locked and the climate control system will operate automatically if the vehicle has the automatic system, or at the same setting as when the vehicle was last turned off. If the vehicle has an automatic climate control system and heated seats, the heated seats turn on Extending Engine Run Time To extend the engine run time by 10 minutes, repeat Steps 1-3 while the engine is still running. The engine run time can only be extended if it is the first remote start since the vehicle has been driven. Remote start can be extended one time.