2013 Chrysler 200 Owner Manual - Page 187

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 185 to pick up the signal during programming. Similar to this Canadian law, some U.S. gate operators are designed to To reprogram a channel that has been previously trained, time-out in the same manner. follow these steps: It may be helpful to unplug the device during the cycling 1. Cycle the ignition to the ON/RUN position. process to prevent possible overheating of the garage 2. Press and hold the desired HomeLink® button until door or gate motor. the indicator light begins to flash after 20 seconds. Do 1. Cycle the ignition to the ON/RUN position. not release the button. Reprogramming A Single HomeLink® Button 3. Without releasing the button proceed with "Program- 2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink® button you wish to program ming A Non-Rolling Code" Step 2 and follow all while keeping the HomeLink® indicator light in view. remaining steps. 3. Continue to press and hold the HomeLink® button, while you press and release ("cycle"), your hand-held For programming transmitters in Canada/United States transmitter every two seconds until HomeLink® has that require the transmitter signals to "time-out" after successfully accepted the frequency signal. The indiseveral seconds of transmission. cator light will flash slowly and then rapidly when Canadian radio frequency laws require transmitter sigfully trained. nals to time-out (or quit) after several seconds of transmission - which may not be long enough for HomeLink® Canadian/Gate Operator Programming 3