2013 Chrysler 200 Owner Manual - Page 219

UNDERSTANDING YOUR INSTRUMENT PANEL 217 For vehicles equipped with the Electronic Vehicle Infor- 17. Electronic Throttle Control (ETC) Indicator Light mation Center (EVIC), refer to "Electronic Vehicle InforThis light informs you of a problem with the mation Center (EVIC)". Electronic Throttle Control (ETC) system. If a 15. Cruise Indicator - If Equipped problem is detected, the light will come on while the engine is running. If the light remains This indicator shows that the Electronic Speed lit with the engine running, your vehicle will usually be Control System is ON. drivable and not need towing, however see your autho16. Odometer/Trip Odometer Reset Button rized dealer for service as soon as possible. If the light is flashing when the engine is running you may experience power loss, an elevated/rough idle, and Press and release this button to change the display from increased brake pedal effort, and your vehicle may odometer to "Trip A." Press and release it a second time require towing. Immediate service is required. to change the display to "Trip B." Press and release it a The light will come on when the ignition switch is first third time to change the display back to the odometer. turned on and remain briefly as a bulb check. This is To reset the trip odometer, first display the trip mileage normal. If the light does not come on during starting, that you want to reset, "Trip A" or "Trip B." Then push have the system checked by an authorized dealer. and hold the button (approximately 2 seconds) until the display resets to 0 miles (km). The odometer must be in Trip Mode to reset the trip odometer. Trip Odometer 4