2013 Chrysler 200 Owner Manual - Page 218

216 UNDERSTANDING YOUR INSTRUMENT PANEL change indicator system is duty cycle based, which means the engine oil change interval may fluctuate If the vehicle diagnostic system detects a leak or change dependent upon your personal driving style. in the evaporative system, or the fuel filler cap is loose, improperly installed, or damaged, the words "gASCAP" Unless reset, this message will continue to display each will display in the odometer display area. If this occurs, time you turn the ignition switch to the "ON" position. To tighten the fuel filler cap properly and press the odom- turn off the message temporarily, press and release the Trip eter reset button to turn off the "gASCAP" message. Odometer button on the instrument cluster. To reset the oil (Refer to "Onboard Diagnostic System - OBD II" in change indicator system (after performing the scheduled "Maintaining Your Vehicle" for further information). If maintenance) perform the following procedure: the problem continues, the message will appear the next Turn the ignition switch to the ON/RUN position (do not time the vehicle is started. See your authorized dealer start the engine). service center as soon as possible. Fully depress the accelerator pedal slowly 3 times within CHANgE OIL 10 seconds. Your vehicle is equipped with an engine oil change indicator system. The "CHANgE OIL" message will flash Turn the ignition switch to the LOCK position. in the instrument cluster odometer for approximately NOTE: If the indicator message illuminates when you 12 seconds after a single chime has sounded to indicate start the vehicle, the oil change indicator system did not the next scheduled oil change interval. The engine oil reset. If necessary, repeat this procedure. gASCAP