2013 Chrysler 300 Owner Manual SRT - Page 492

490 MAINTAINING YOUR VEHICLE Adding Washer Fluid The windshield washer fluid reservoir is located in the front of the engine compartment. Be sure to check the fluid level at regular intervals. Fill the reservoir with windshield washer solvent (not radiator antifreeze) and operate the system for a few seconds to flush out the residual water. WARNING! Commercially available windshield washer solvents are flammable. They could ignite and burn you. Care must be exercised when filling or working around the washer solution. Exhaust System When refilling the washer fluid reservoir, apply some The best protection against carbon monoxide entry into washer fluid to a cloth or towel and wipe the wiper the vehicle body is a properly maintained engine exhaust blades clean. This will help blade performance. system. To prevent freeze-up of your windshield washer system in If you notice a change in the sound of the exhaust system; cold weather, select a solution or mixture that meets or or if the exhaust fumes can be detected inside the vehicle; exceeds the temperature range of your climate. This rating or when the underside or rear of the vehicle is damaged; information can be found on most washer fluid containers. have an authorized technician inspect the complete exThe fluid reservoir will hold nearly 1 gal (4 L) of washer haust system and adjacent body areas for broken, damfluid when the message "Low Washer Fluid" appears in the aged, deteriorated, or mispositioned parts. Open seams Electronic Vehicle Information Center (EVIC) (if equipped). or loose connections could permit exhaust fumes to seep