2013 Chrysler 300 Owner Manual SRT - Page 55

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 53 As a guide, if you are shorter than average you will prefer a lower position, and if you are taller than average you will prefer a higher position. When you release the anchorage try to move it up and down to make sure that it is locked in position. Seat Belts In Passenger Seating Positions The seat belts in the passenger seating positions are equipped with Automatic Locking Retractors (ALR) which are used to secure a child restraint system. For additional information, refer to "Installing Child ReLap/Shoulder Belt Untwisting Procedure straints Using The Vehicle Seat Belt" under the "Child Use the following procedure to untwist a twisted lap/ Restraints" section. The chart below defines the type of feature for each seating position. shoulder belt. 1. Position the latch plate as close as possible to the anchor point. 2. At about 6 to 12 in (15 to 30 cm) above the latch plate, grasp and twist the belt webbing 180 degrees to create a fold that begins immediately above the latch plate. Driver N/A ALR Center N/A ALR Passenger ALR ALR 2 First Row Second Row 3. Slide the latch plate upward over the folded webbing. • N/A - Not Applicable The folded webbing must enter the slot at the top of • ALR - Automatic Locking Retractor the latch plate. 4. Continue to slide the latch plate up until it clears the folded webbing.