2010 Dodge Challenger Owner Manual SRT8 - Page 141

140 UNDERSTANDING THE FEATURES OF YOUR VEHICLE previous set speed. To do so, push the lever upward to until the lever is released. Release the lever when the RESUME ACCEL and release. Then remove your foot desired speed is reached, and a new set speed will be established. from the accelerator pedal. To Vary the Speed Setting When the Electronic Speed Control is set, you can increase speed by pushing up and holding the RESUME ACCEL lever. If the lever is continually held in the RESUME ACCEL position, the set speed will continue to increase until the lever is released, then the new set speed will be established. Tapping the SET DECEL lever once will result in a 1 mph (2 km/h) decrease in set speed. Each subsequent tap of the lever results in a decrease of 1 mph (2 km/h). To Accelerate For Passing Press the accelerator as you would normally. When the pedal is released, the vehicle will return to the set speed. Using Electronic Speed Control on Hills Tapping the RESUME ACCEL lever once will result in a 1 mph (2 km/h) increase in set speed. Each subsequent NOTE: The Electronic Speed Control system maintains tap of the lever results in an increase of 1 mph (2 km/h). speed up and down hills. A slight speed change on moderate hills is normal. To decrease speed while Electronic Speed Control is set, push down and hold the Electronic Speed Control lever The automatic transmission will downshift while climbin SET DECEL. If the lever is continually held in the SET ing uphill or descending downhill. This downshift is DECEL position, the set speed will continue to decrease necessary to maintain vehicle set speed.