2010 Dodge Challenger Owner Manual SRT8 - Page 356

MAINTAINING YOUR VEHICLE 355 Operation of the wipers on dry glass for long periods reservoir with windshield washer solvent (not radiator may cause deterioration of the wiper blades. Always use antifreeze) and operate the system for a few seconds to washer fluid when using the wipers to remove salt or dirt flush out the residual water. from a dry windshield. When refilling the washer fluid reservoir, apply some Avoid using the wiper blades to remove frost or ice from washer fluid to a cloth or towel and wipe the wiper the windshield. Keep the blade rubber out of contact with blades clean. This will help blade performance. petroleum products such as engine oil, gasoline, etc. To prevent freeze-up of your windshield washer system NOTE: Life expectancy of wiper blades varies depend- in cold weather, select a solution or mixture that meets or ing on geographical area and frequency of use. Poor exceeds the temperature range of your climate. This performance of blades may be present with chattering, rating information can be found on most washer fluid marks, water lines or wet spots. If any condition is containers. present please proceed to clean wiper blades with humid The fluid reservoir will hold nearly 1 gal (4 l) of washer cloth removing any debris that may be affecting its fluid when the message "Low Washer Fluid" appears in function. the Electronic Vehicle Information Center (EVIC). Adding Washer Fluid The windshield washer fluid reservoir is located in the front of the engine compartment. Be sure to check the fluid level in the reservoir at regular intervals. Fill the 7