2010 Dodge Challenger Owner Manual SRT8 - Page 334

WHAT TO DO IN EMERGENCIES 333 4. Have the tire inspected and repaired or replaced at the 3. Use the yellow cap on end of the Sealant Hose (6) to earliest opportunity at an authorized dealer or tire ser- depress the Sealant Bottle release button. The Sealant Bottle (1) will pop up. Remove the bottle and dispose of vice center. it accordingly. 5. Replace the Sealant Bottle (1) and Sealant Hose (6) assembly at your authorized dealer as soon as possible. 4. Clean any remaining sealant from the TIREFIT housing. Refer to "(F) Sealant Bottle and Hose Replacement." NOTE: When having the tire serviced advise the autho- 5. Position the new Sealant Bottle (1) to the housing so that rized dealer or service center that the tire has been sealed the Sealant Hose (6) aligns with the hose slot in the front of the housing and the alignment keys on the bottom of the using the TIREFIT service kit. bottle align with the alignment slots in the housing. Then, (F) Sealant Bottle and Hose Replacement: press the bottle into the housing. An audible click will be 1. Uncoil the Sealant Hose (6). heard, indicating the bottle is locked in place. 2. Locate the rectangular Sealant Bottle release button in 6. Verify the yellow cap is installed on the fitting at the the recessed area where you place your fingers to unlatch end of the Sealant Hose (6) and return the hose to its storage area (located on the bottom of the air pump). the hoses (6) (7) from their storage area. 7. Return the TIREFIT kit to its storage location in the vehicle. 6