2010 Dodge Challenger Owner Manual SRT8 - Page 47

46 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 3. Within 60 seconds of turning the ignition switch to the BeltAlert௡ Programming The BeltAlert௡ can be enabled or disabled by your ON/RUN position, unbuckle and then re-buckle the authorized dealer or by performing the following steps: driver's seat belt at least three times, ending with the seat belt buckled. NOTE: Chrysler Group LLC does not recommend deactivating the BeltAlert௡. NOTE: Watch for the Seat Belt Reminder Light to turn on while unbuckling the seat belt and turn off while 1. With both doors closed, and the ignition switch in any re-buckling the seat belt. It may be necessary to retract position except ON/RUN or START, buckle the driver's the seat belt. seat belt. 4. Turn the ignition switch to the OFF position. A single 2. Turn the ignition switch to the ON/RUN position, but chime will sound to signify that you have successfully do not start the engine. Wait for the Seat Belt Reminder completed the programming. Light to turn off and then proceed to the next step. The BeltAlert௡ can be reactivated by repeating this proNOTE: You must perform the following steps within cedure. 60 seconds of turning the ignition switch to the ON/RUN position. NOTE: When the BeltAlert௡ is deactivated, the Seat Belt Reminder Light will continue to illuminate as long as the driver's seat belt is unbuckled.