2013 Dodge Dart Owner Manual - Page 232

230 UNDERSTANDING THE FEATURES OF YOUR VEHICLE NOTE: After pressing the OFF button a "Cruise Control Pressing the RES (+) button once will result in a 1 mph off" message is displayed for 5 seconds or until another (1 km/h) increase in set speed. Each subsequent tap of the button results in an increase of 1 mph (1 km/h). switch is pressed. For analog speedometer: The white outer line on the To decrease speed while the Electronic Speed Control is set, push the SET (-) button. If the button is continually speedometer returns to red. held in the SET (-) position, the set speed will continue to For digital speedometer: The MPH reading returns from decrease until the button is released. Release the button red to white. when the desired speed is reached, and the new set speed will be established. To Resume Speed To resume a previously set speed, push the RES (+) Pressing the SET (-) button once will result in a 1 mph button and release. Resume can be used at any speed (1 km/h) decrease in set speed. Each subsequent tap of above 20 mph (32 km/h). the button results in a decrease of 1 mph (1 km/h). To Vary The Speed Setting NOTE: Tap results of 1 mph ( 1 km/h ) depends on When the Electronic Speed Control is set, you can inselection of US or Metric units using the left hand crease speed by pushing the RES (+) button. If the button Steering Wheel Buttons, and EVIC display. is continually pressed, the set speed will continue to increase until the button is released, then the new set speed will be established.