2013 Dodge Dart Owner Manual - Page 507

WHAT TO DO IN EMERGENCIES 505 2. Locate the round Sealant Bottle release button in the JUMP-STARTING PROCEDURES If your vehicle has a discharged battery it can be jumprecessed area under the sealant bottle. started using a set of jumper cables and a battery in 3. Press the Sealant Bottle release button. The Sealant another vehicle or by using a portable battery booster Bottle (1) will pop up. Remove the bottle and dispose of pack. Jump-starting can be dangerous if done improperly it accordingly. so please follow the procedures in this section carefully. 4. Clean any remaining sealant from the TIREFIT housNOTE: When using a portable battery booster pack ing. follow the manufacturer's operating instructions and 5. Position the new Sealant Bottle (1) in the housing so precautions. that the Sealant Hose (6) aligns with the hose slot in the CAUTION! front of the housing. Press the bottle into the housing. An audible click will be heard indicating the bottle is locked Do not use a portable battery booster pack or any into place. other booster source with a system voltage greater 6. Verify that the cap is installed on the fitting at the end than 12 Volts or damage to the battery, starter motor, of the Sealant Hose (6) and return the hose to its storage alternator or electrical system may occur. area (located on the bottom of the air pump). 7. Return the TIREFIT kit to its storage location in the vehicle. 6