2013 Dodge Dart Owner Manual - Page 301

UNDERSTANDING YOUR INSTRUMENT PANEL 299 Engine Oil Change Indicator System Oil Change Required Your vehicle is equipped with an engine oil change indicator system. The "Oil Change Required" message will flash in the EVIC display for approximately 10 seconds after a single chime has sounded, to indicate the next scheduled oil change interval. The engine oil change indicator system is duty cycle based, which means the engine oil change interval may fluctuate, dependent upon your personal driving style. Vehicles Not Equipped With Keyless Enter-N-Go™ Unless reset, this message will continue to display each 1. Turn the ignition switch to the ON/RUN position (Do time you turn the ignition switch to the ON/RUN not start the engine.) position or cycle the ignition to the ON/RUN position if 2. Fully depress the accelerator pedal, slowly, three times equipped with Keyless Enter-N-Go™. To turn off the within 10 seconds. message temporarily, press and release the MENU but- 3. Turn the ignition switch to the OFF/LOCK position. ton. To reset the oil change indicator system (after performing the scheduled maintenance) refer to the fol- NOTE: If the indicator message illuminates when you start the vehicle, the oil change indicator system did not lowing procedure. reset. If necessary, repeat this procedure. Vehicles Equipped With Keyless Enter-N-Go™ 1. Without pressing the brake pedal, press the ENGINE START/STOP button and cycle the ignition to the ON/ RUN position (Do not start the engine.) 2. Fully depress the accelerator pedal, slowly, three times within 10 seconds. 3. Without pressing the brake pedal, press the ENGINE START/STOP button once to return the ignition to the OFF/LOCK position. 4