2013 Dodge Dart Owner Manual - Page 33

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 31 • The engine can be started two consecutive times (two 15-minute cycles) with the RKE transmitter. However, the ignition must be cycled to the RUN position before you can repeat the start sequence for a third cycle. To Exit Remote Start Mode And Drive The Vehicle Before the end of 15 minute cycle, press and release the UNLOCK button on the RKE transmitter to unlock the doors and disarm the Vehicle Security Alarm (if equipped). Then, prior to the end of the 15 minute cycle, To Exit Remote Start Mode Without Driving The press and release the START/STOP button (vehicles Vehicle equipped with Keyless Enter-N-Go™) or insert the key Press and release the REMOTE START button one time or and turn it to the RUN position (vehicles not equipped allow the engine to run for the entire 15 minute cycle. with Keyless Enter-N-Go™). NOTE: To avoid unintentional shutdowns, the system NOTE: The message ЉRemote Start Active Push Start will disable the one time press of the REMOTE START ButtonЉ (vehicles equipped with Keyless Enter-N-Go™) button for two seconds after receiving a valid Remote or ЉRemote Start Active Key to RunЉ (vehicles not Start request. equipped with Keyless Enter-N-Go™) will display in the EVIC until you push the START button or turn the key to the RUN position. 2