2000 Ford Windstar Owner Guide 1st Printing - Page 103

Controls and features Safety/Obstructions If anything obstructs the Power Sliding Door while it is closing, the door will automatically reverse to the open position, provided it meets sufficient resistance. Resetting the PSD The power sliding door may operate incorrectly or not at all because of the following condition: • a low voltage or dead battery • disconnecting the battery • if the PSD fuse (fuse #6) is removed or blown. Refer to Fuses and relays in the Roadside emergencies chapter. If any of these conditions occur, reset the PSD by: 1. Check to see if power sliding door is unlocked and securely closed. 2. Make sure the gearshift is in (P) Park. 3. Push the power door control on the overhead console to open the door. 4. Wait five (5) seconds and close the door by pressing the power door control on the overhead console. 5. Wait five (5) seconds and repeat Steps 3 and 4 and go on to step 6. 6. Repeat steps 3-5 for opposite door. If the door does not rest in the fully open position, repeat Steps 1-4 again. If the door still does not operate correctly: 7. Turn the ignition switch to OFF. 8. Remove the PSD fuse (fuse #6) from the passenger fuse panel and leave it out for thirty (30) seconds. Refer to Fuses and relays in the Roadside emergencies chapter. 9. Reinstall the fuse and wait ten (10) seconds. 10. Repeat steps 1-6 above. If the door still does not operate correctly, see your dealer for service. Sliding Door Child Safety Lock Your vehicle is equipped with a sliding door child safety lock that helps prevent passengers from operating the sliding door by using the inside door handle. This lock is on both doors if equipped. The child safety lock 103