2000 Ford Windstar Owner Guide 1st Printing - Page 247
2000 Ford Windstar Manual
Page 247 highlights
Maintenance and care 4. Use an E8 Torx socket to turn the horizontal adjusting screw until the "0" mark on the yellow dial lines up with the reference mark on the marker (as shown) when viewed directly from above. 5. When the horizontal aim has been adjusted, close the hood. Vertical aim adjustment The numbers shown on the vial indicate beam direction in degrees up or down. 1. Park the vehicle on a level surface 2. Locate the bubble level vertical aim indicator located on the bottom shelf of the headlamp reflector, visible through the headlamp lens. U D 3. With the hood open, locate the vertical adjusting screw on the outer top of the headlamp. 4. Using an E8 Torx socket rotate the adjusting screw until the bubble in the vial is centered between the two white lines (which represent the "0" mark) when viewed from the front of the lens. 5. When the horizontal and vertical indicators are set to the "0" mark, the headlamp has been properly aimed. 6. Close the hood. 247