2000 Ford Windstar Owner Guide 1st Printing - Page 140

Seating and safety restraints Replacing the second row bench seat belt assemblies after a collision All second row bench seat belt assemblies adjacent to a sliding door have special energy management retractors designed to further reduce the risk of injury in the event of a head-on collision. These retractors should be replaced if they were used in any accident in which the front airbags deploy. If the safety belt assemblies are not replaced, there may be increased risk of injury in the event of a subsequent collision. Failure to inspect and if necessary replace the safety belt assembly under the above conditions could result in severe personal injuries in the event of a collision. AIR BAG SUPPLEMENTAL RESTRAINT SYSTEM (SRS) O/D OFF F E FUEL 3 2 1 TRAC OFF 4 5 6 TRAC ACTIVE 7 THEFT 40 20 40 60 80 BRAKE O/D F ON/OF INFO 120 80 100 160 km/h TEMP H SETUP RPMX1000 RESET MPH mi VOL - PUSH ON OFF DISC EJ FM1 ST FM1 ST AUTO P T/C MUTE AM SEEK TUNE REW FM DOLBY B NR EJ TAPE CD AUTO CLK SCAN FF BASS TREB SIDE 1-2 SEL BAL COMP FADE SHUFFLE 1 2 3 4 5 6 FRONT REAR MAX A/C OFF REAR CONT A/C Your vehicle is equipped with a crash sensing and diagnostic module which records information about the air bag and sensor systems. In the event of a collision this module may save information related to the collision including information about the air bag system and impact severity. This information will assist Ford in the servicing of your vehicle and may help Ford better understand real world collisions and further improve the safety of future vehicles. 140