2000 Ford Windstar Owner Guide 1st Printing - Page 18

Instrumentation The sequence of the system check report is as follows: 1. oil life in XX% 2. charging system 3. washer fluid level 4. brake fluid level 5. doors closed (driver and passenger side). This message can only be reset by closing the door(s). If the RESET control is pressed, PLEASE CLOSE DOOR will be displayed. 6. rear liftgate status 7. exterior lamps (headlamps, front turn, brake, tail and cornering/side repeater lamp status) 8. traction control (if equipped) 9. fuel level 10. distance to empty Single/Dual Display Mode 1. Select this function from the SETUP menu for the current display mode. 2. Press the RESET control to change from the Single to the Dual display. > System warnings System warnings alert you to possible problems or malfunctions in your vehicle's operating systems. In the event of a multiple warning situation, the message center will cycle the display to show all warnings by displaying each one for 4 seconds. The message center will display the last selected feature if there are no more warning messages. This allows you to use the full functionality of the message center after you acknowledge the warning by pressing the RESET control and clearing the warning message. Warning messages that have been reset are divided into two categories: • They will reappear on the display ten minutes from the reset. • They will not reappear until an ignition OFF-ON cycle has been completed. 18