2010 Ford Explorer Owner Guide 2nd Printing (Spanish) - Page 491

Instrument Cluster Usually, when something affects the compass readings, the compass will correct itself after a few days of operating your vehicle in normal conditions. If the compass still appears to be inaccurate, a manual calibration may be necessary. Refer to RESET FOR ZONE SETTING / PRESS RESET FOR CALIBRATION following. Most geographic areas (zones) have a magnetic north compass point that varies slightly from the northerly direction on maps. This variation is four degrees between adjacent zones and will become noticeable as the vehicle crosses multiple zones. A correct zone setting will eliminate this error. Refer to RESET FOR ZONE SETTING / PRESS RESET FOR CALIBRATION following. RESET FOR ZONE SETTING 1. Determine your magnetic zone by referring to the zone map. 3 2 1 15 2. Start the engine. 3. Press the SETUP button to select 4 14 RESET FOR ZONE SETTING. 13 4. Press the RESET button until the 5 12 message center display changes to show the current zone setting (XX). 5. Press the RESET button 6 7 8 9 1011 repeatedly until the correct zone setting for your geographic location is displayed on the message center. The range of zone values are from 01 to 15 and "wraps" back to 01. 6. Wait four seconds when correct zone is chosen. PRESS RESET FOR CALIBRATION Perform compass calibration in an open area free from steel structures and high voltage lines. For optimum calibration, turn off all electrical accessories (heater/air conditioning, wipers, etc.) and make sure all vehicle doors are shut. 1. Press the SETUP button to select PRESS RESET FOR CALIBRATION. 2. Press RESET to calibrate. 3. Slowly drive the vehicle in a circle (less than 3 mph [5 km/h]) until the CIRCLE SLOWLY TO CALIBRATE display changes to CALIBRATION COMPLETED. It will take up to five circles to complete calibration. 4. The compass is now calibrated. 35 2010 Explorer (exp) Owners Guide, 2nd Printing USA (fus)